![\"\"](\"http:\/\/armahobbynews.pl\/wp-content\/uploads\/p11c_kabina_01.jpg\")
<\/a><\/p>\nI cut all parts out of the frame<\/p>\n
I cleaned the parts with standard modeling tools<\/p>\n The arrows show where to assembly the parts on the outside of the right frame<\/p>\n Install the oxygen tank at two points<\/p>\n Attach the side panel with two clocks with the small gap to the frame, on the right below of a place for switch-box<\/p>\n Switch-box in place<\/p>\n Left frame, outside MG mount and a Viet starter<\/p>\n The left frame is ready<\/p>\n The floor requires sanding the back edge to accommodate the PE13 photo-etched part<\/p>\n Port side parts attachment points<\/p>\n Parts glued in place<\/p>\n The floor with a control column and ruder pedals assembled<\/p>\n The floor with right and left frames. The places where the parts are joined are marked. It is important that the bottom of the MG (ammunition feed channels) is well cleaned of the sprue runners, thanks to that the sides will come down with the floor at right angles<\/p>\n Right frame glued to the floor<\/p>\n From the bottom you can see parts connection points<\/p>\n And the left frame glued<\/p>\n Second shot. It is worth placing the glued module on a flat surface and make sure that both frames are parallel to the plane and, in the front view, perpendicular to the floor sides<\/p>\n Places for undercutting the headrest as described in the errata<\/a> (on both sides). It is best to lightly sand the edges after the undercut<\/p>\n It is recommended to dry fit the headrest and the fuselage. If it fits the outline of the fuselage behind the headrest, it ensures have done the correction well<\/p>\n Headrest attachment points between the right and left frame<\/p>\n After inserting between the frames, rotate the headrest vertically…<\/p>\n …this way<\/p>\n The head restforms a straight line with the rear of the frame<\/p>\n The place of fixing the pilot\u2019s seat base<\/p>\n The base of the seat is glued into place<\/p>\n Pay attention: part flor and seat base should be perpendicular<\/p>\n The seat rests on its base and the lower part of the frame, below the headrest<\/p>\n Place of assembly of the instrument panel<\/p>\n Ready cockpit interior module placed in the fuselage half<\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n